2.0L (2264cc) Duratec/ MZR Stroker Shortblocks
- Brand: Esslinger Engineering
- Product Code: 2.0L (2264cc) Duratec/ MZR Stroker Shortblocks
- Availability: In Stock
Choose from 3 different compression ratio/ option packages to suit your specific needs. All our 2.3L stroked 2.0L shortblocks have an actual dis..
Available Options
Choose from 3 different compression ratio/ option packages to suit your specific needs. All our 2.3L stroked 2.0L shortblocks have an actual displacement of 2264cc and are assembled by the same technicians that build our race and championship winning engines. We take the same level of detail and care when assembling each shortblock from the lowest to highest compression. Each shortblock package has parts picked out to work the best in each given application. Check out the parts lists and accompanying machinework for each of the options below to help you choose which shortblock will fit your needs the best!
Options:
10.5:1 Compression E-series (good for 91/93 octane normally aspirated engines spinning up to 8000+rpm)
12:1 Compression E-series (good for normally aspirated engines spinning up to 8000+rpm using Stage 4 or larger cams)
13.5:1 Compression R-series (good for normally aspirated engines spinning up to 9000rpm on E85/ or 110 octane fuel while using our Stage 4 or larger cams)
As with all our shortblock, and complete engine offerings, we start with a brand new block, inspect it for imperfections, dimensions, or damage, before completing the following modifications:
Tap front and rear oil galleys for -8AN O-ring plugs
Tap intake side oil galley for -4AN O-ring plug
Surface Block deck square to crank centerline
Surface Girdle as needed
Install new main girdle hardware (Options: E-series get OEM main bolts & R-series get ARP Main Stud Kit)
Align hone main tunnel to size
Install ARP Head Stud Kit for torque plate (stud kit hardware available separately)
Torque Plate Hone cylinders to the correct surface finish & clearance for our 3.448" (87.578mm) bore stroker pistons
Drill & tap VCT oil feed hole for thread in plug (Drill & tapping for plug is optional, block comes without plug as standard)
Debur all interior and exterior surfaces
Preliminary wash to remove machining chemicals & chips (with an additional final wash before assembly)
Measure all critical dimensions as Quality Control (bore, deck height, main housing bore dia., & cylinder surface finish)
Install new heater hose elbow above water inlet (** We can plug this port on engines without a thermostat**)
Includes new Head Dowels
Includes new Bellhousing Dowels
Includes new piston squirters
Includes new -8AN front & rear oil galley plugs
Includes new -4AN side oil galley plug
*** If needed, we can include a VCT oil galley plug for those not using a VCT cylinderhead ***
